David Walden

• Post By David Walden
• 1 month ago
• Post Type Public

Component 5, (Nacelle_Top) and Component 7 (Nacelle_Bottom) are experiencing failure to mesh. Can you take a look? It might be obvious to you.

Here's a download link to the compressed project file for your review. Please see my comment for a better Component map image for reference.

Edit: I've even tried performing the meshing operation using Salome-Meca. Meshing just one stl fails with it too, but unlike TCAE, takes several hours to fail completely. The component 5 (fuchsia) is Nacelle_Top, the patch in question is named Solid_Top_Bell-Mouth_inlet_and_Duct_Surface_08_21_25a.

I suspect Nacelle_Bottom is going to be just as bad, or worse, than Nacelle_Top. It is slightly smaller in diameter, but it's a more complicated surface.

Thanks in advance,

David