- Post By Ashton Thomas
- 3 months ago
- Post Type Public
Mesh for component 1 was created incorrectly.
The patch(es) "1:Part_Studio_1_-_Outlet" has/have not been found in just created mesh.
There might be two reasons for that:
- Either the patch is so small, so the it was not possible to properly mesh it.
Check the patch visually, and also its meshing parameters.
- Second reason might be, that this patch is located outside the meshed geometry, and therefore cannot be meshed.
Again check the patch visually.
CFD meshing failed
I originally had this error on the Inlet patch, I don't know what I changed to correct that (nothing I believe)
The patch is not small, it appears water tight. It comes from a watertight model.
The patch is within the meshed geometry.
I've not had this error before, I've not struggled with meshing previously.
