Hi there

I don't know if tihs would help but I was wondering if anyone can help me to apply a "opening" condition in OpenFoam, in the picture you can see almost a square, and what I have in my problem is that from a little part of the left side I have an inlet and a part of the top part I have an outlet. Also I know that my outlet takes twice the flow that goes in from the inlet, and in t...

Hey, I was wondering if anyone could help me to understand the different solvers OpenFoam has for different purposes, I thing I have understood icoFoam and simpleFoam but if anyone could help me to know when and how to use the potentialFoam and all of them I would appreciate it a lot.

Thanks in advance for the help 

Hi, I'm a newbie to OpenFoam and I was trying to do the tutorials, I've been doing great but then I got to the motorbike one and tried to run in parallel the meshing and simulation but didn't work.

As you can see I set my meshing for parallel and gives me errors no matter if I use mpirun or mpiexec (I used both of them because I saw in other forums one of those should work), however if I...