Mesh for component 1 was created incorrectly.

The patch(es) "1:Part_Studio_1_-_Outlet" has/have not been found in just created mesh.

There might be two reasons for that:

- Either the patch is so small, so the it was not possible to properly mesh it.

Check the patch visually, and also its meshing parameters.

- Second reason might be, that this patch is located...

Hi All,

New user here. I've gone through the tutorials and forum but haven't found my answer. Asking the AI chat bot it says I need to do some scripting and change some files, which I don't believe. I feel the answer is more straight forward.

How do I measure the mass flow rate through my system? You can set the units for the report, but my report shows nothing...